Mapp Connect Connector Setup Guide
This article describes how to set up the Mapp Connect connector.
Actions
| Action name | AudienceStream | EventStream |
|---|---|---|
| Create or Update Contact | ✓ | ✓ |
| Remove Contact from Group | ✓ | ✓ |
Configuration
Navigate to the Connector Marketplace and add a new connector. For general instructions on how to add a connector, see About Connectors.
After adding the connector, configure the following settings:
- Integration ID
The ID of the Mapp integration to send data to. - API URL
The URL for the API endpoint, which does not need to include the protocol. - API Secret
The secret key generated within Mapp for generating a JWT for authentication. For more information, see Mapp: Create an integration.
Actions
The following section lists the supported parameters for each action.
Create or Update Contact
Parameters
| Parameter | Description |
|---|---|
| Group ID | The group ID to add the contact to. This is required when the contact does not exist in Mapp. |
User Parameters
| Parameter | Description |
|---|---|
| (Required) The contact’s email address. |
Remove Contact from Group
Parameters
| Parameter | Description |
|---|---|
| Group ID | The group ID to remove the contact from. This is required when the contact does not exist in Mapp. |
User Parameters
| Parameter | Description |
|---|---|
| (Required) The contact’s email address. |
This page was last updated: June 14, 2024